- cross-posted to:
- [email protected]
- cross-posted to:
- [email protected]
cross-posted from: https://lemm.ee/post/28863694
Video https://www.youtube.com/watch?v=O1p7Sn1eMmE
I didn’t know about this command. I was trying to create an assembly. I knew that Solidworks had mating commands in the assembly, but I couldn’t find them in Fusion 360. (I refuse to call it just Fusion, that’s stupid.) So, watching assembly tutorials, I found this. I never knew the Align command existed or what it did. Sigh.
PS DAPTeach or dapteach9020, your video is great, I wish I could tell you but you have comments turned off and no way to contact you and no videos in 3 years.
You must log in or register to comment.
Here is an alternative Piped link(s):
https://www.piped.video/watch?v=O1p7Sn1eMmE
Piped is a privacy-respecting open-source alternative frontend to YouTube.
I’m open-source; check me out at GitHub.
