I’m pretty new to PETG, and have been really struggling with it compared to PLA. My latest print of this part is dimensionally accurate, but I need it to be air tight. It is very much not at the moment.

I have a Flashforge Adventurer 3, so the hot end and nozzle are one interchangeable unit. My higher temp nozzle is 0.6mm. My 0.3mm is only capable of 240. My last print was 0.2mm layers, with the 0.6mm nozzle at 245C. I used 15% overlap on my walls, and in order to keep my nice dimensions I had my cooling fan on.

Anybody have any advice on how to improve the seal? I’m tempted to try more overlap, with random start locations per layer. Do you think if I run it hotter I can get the layers a little thinner? Any advice would be appreciated.

  • ffhein@lemmy.world
    link
    fedilink
    English
    arrow-up
    2
    ·
    edit-2
    1 year ago

    PLA is not one of the filaments that can be vapour smoothed with household chemicals afaik. I don’t think you’ll have more success with than the PETG. Sounds like PVB might be more suitable for your project, since it’s transparent and can be smoothed with IPA.

    • nyan@lemmy.cafe
      link
      fedilink
      English
      arrow-up
      2
      ·
      1 year ago

      Technically, any filament can be smoothed if you’re willing to use sufficiently noxious chemicals. Ethyl acetate is apparently the least noxious smoother for PLA—it’s used in perfumes and can be purchased off Amazon, Ebay, and other large marketplaces. Not something you’d have lying around, but I don’t think it’s terribly toxic, either (never tried it myself). Still, check some MSDSs or the like before you shoot off and buy some.

      • ffhein@lemmy.world
        link
        fedilink
        English
        arrow-up
        1
        ·
        1 year ago

        Well, that’s why I wrote household chemicals :) TIL about ethyl acetate though, I’ve always heard chloroform being the best solvent for PLA.

        • nyan@lemmy.cafe
          link
          fedilink
          English
          arrow-up
          2
          ·
          1 year ago

          Well, I only claimed that ethyl acetate was the least noxious, not the most effective—Wikipedia claims a low overall toxicity, and use in skin contact and even food applications. Chloroform seems like it would be slightly higher-risk. 😉