Michael Andretti says he is still hoping to be on the grid in 2025, but still waiting for conversations with F1/FOM to even begin.

Source

    • GeneralEmergency@lemmy.world
      27·
      9 months ago

      Again you’re being deliberately obtuse.

      If there are rules regarding wind tunnels and you want to show you can build an F1 car to spec, why use a wind tunnel that doesn’t follow those rules.

      There is no way you can see Andretti build a model to F1 spec and test it in a wind tunnel used by F1 teams. And not understand the significance of that.

      • woelkchen@lemmy.world
        22·
        9 months ago

        If there are rules regarding wind tunnels

        I’ve linked to the PDF of the rules. There are no wind tunnel rules.

        • GeneralEmergency@lemmy.world
          21·
          9 months ago

          That’s because those rules are in the sporting regulations. Appendix 7

          The following restrictions apply during RWTT: a. Only wind tunnels that use air at atmospheric pressure as the test fluid are permitted. Other than rotations of the RATG and model or ground plane about the yaw axis, designs which attempt to create curved flow conditions relative to the RATG are not permitted. For closed section wind tunnels adaption of vertical walls and the ceiling to improve air flow uniformity is permitted. Particle image velocimetry systems where the wind tunnel air transports a flow visualisation medium are permitted. b. No RWTT may be carried out using a scale model and RATG which is greater than 60% of full size neither may it be carried out at a wind tunnel air speed exceeding 50m/s measured relative to the scale model and RATG. Furthermore, during restricted wind tunnel testing the magnitude of the rate of change of the wind tunnel air speed measured relative to the scale model and RATG must be less than 4.5m/s². The rate of change of the wind tunnel air speed will be defined as the derivative of wind tunnel air speed and smoothed using a moving average filter, centred on each sample, of period 0.5 seconds during each wind tunnel air speed ramp up and ramp down phase. These phases are defined as the periods when the wind tunnel air speed is varying between 15m/s and 95% of the maximum wind tunnel air speed during a run.

          There’s quite a bit about it in there. You should read it some times. https://www.fia.com/regulation/category/110

            • GeneralEmergency@lemmy.world
              21·
              9 months ago

              Didn’t know you have intricate knowledge of GM wind tunnels. It also wouldn’t meet those regulations. Appendix 7 Article 3.

              • woelkchen@lemmy.world
                21·
                9 months ago

                Didn’t know you have intricate knowledge of GM wind tunnels.

                You claim to know with your “intricate knowledge” why they were not used, so…

                There are detailed tours of the facilities which I looked up and you clearly didn’t when claiming that GM’s don’t conform to regulations and still can’t point out why they don’t…

                It also wouldn’t meet those regulations. Appendix 7 Article 3.

                GM’s meet those.

                • “Only wind tunnels that use air at atmospheric pressure as the test fluid are permitted.” ☑️ They use regular air.

                • “Other than rotations of the RATG and model or ground plane about the yaw axis, designs which attempt to create curved flow conditions relative to the RATG are not permitted.” ☑️ Floor is flat.

                • “No RWTT may be carried out using a scale model and RATG which is greater than 60% of full size” ☑️ That’s a limitation of the model size, not the tunnel itself

                • “during restricted wind tunnel testing the magnitude of the rate of change of the wind tunnel air speed measured relative to the scale model and RATG must be less than 4.5m/s²” ☑️ They can regulate the speed

                • “Only one model and RATG may be used per run.” ☑️ Again not a limitation of the tunnel itself

                • “The only permitted degrees of freedom of the model and RATG during a run of RWTT are…” ☑️ Again not a limitation of the tunnel itself

                • “Where non-rigid wind tunnel tyres are used for RWTT these may only be produced by the appointed tyre supplier.” ☑️ Again not a limitation of the tunnel itself

                Edit: I forgot to thank you for linking those regulations. Didn’t think to look at sporting regs instead of technical regs. Reading through them confirmed that GM’s wind tunnels conform to the regs.

                • GeneralEmergency@lemmy.world
                  13·
                  9 months ago

                  Again I will direct you to Appendix 7 Article 3. Literally the first sentence.

                  But also on the Toyota wind tunnel. It’s specifically set up for Motorsport. It’s the Gazoo Racing facilities. McLaren used it, Force India used it, There’s probably countless other smaller teams that use it. It also features a rolling road and fancy laser sensors.

                  Meanwhile the first search for GM wind tunnel, shows one that takes clay models on a stationary platform.

                  Even someone as obtuse as you could make the connection they’re using the Toyota tunnel.

                  • woelkchen@lemmy.world
                    21·
                    9 months ago

                    Again I will direct you to Appendix 7 Article 3. Literally the first sentence.

                    “The following restrictions apply during RWTT: Only wind tunnels that use air at atmospheric pressure as the test fluid are permitted.” That’s the first sentence in 2023 rules to which the model has been built and I already wrote that they use regular air.

                    It’s specifically set up for Motorsport. It’s the Gazoo Racing facilities. McLaren used it, Force India used it, There’s probably countless other smaller teams that use it. It also features a rolling road and fancy laser sensors.

                    That’s not a reason why GM’s don’t conform to the rules as you repeatedly claimed without ever going into detail.

                    Btw. I’m well aware of the facilities relatively close to where I live. I don’t need introduction to Toyota’s Cologne facilities.

                    Meanwhile the first search for GM wind tunnel, shows one that takes clay models on a stationary platform.

                    That’s your research into GM’s wind tunnels? Not surprising that you cannot point to where the car company that owns several wind tunnels, incl the world’s biggest automotive wind tunnel, doesn’t comply.

                    someone as obtuse as you

                    You’re again resorting to insults without being capable to point to specifics. What happened to you that you act this way?