I moved my business into a new building, and there is a doorway i want to put up a door in it. However the doorway is about 1/4" narrower at the bottom, than the top. Neither of the top corners are square. I am looking for the easiest way with the least amount of work and knowledge needed to hang this door. It is only a barrier, it is not for security. It will be closed most of the time, so i am not worried if it is going to naturally swing open or closed.

Also, the cuts for the hinges on the door and the frame do not line up. I am fine with buying a new door, but I would rather not replace the frame of i can avoid it.

Any suggestions?

      • dan@upvote.au
        71·
        3 months ago

        Depends on the quality of the door. My house was built in the 1960s and most of the interior doors aren’t hollow.

        • Altima NEO@lemmy.zipEnglish
          5·
          3 months ago

          I dunno, mine’s a 70 and they’re hollow and thin. But In this case, it sounds like they’re trying to fit a new door in an existing opening, so I’m assuming its a hollow interior door.

          • nocturne@sopuli.xyzOP
            2·
            3 months ago

            It is a hollow door, but the amount of planing needed at the bottom is minor, I am more worried about the 1/4” gap at the top.

      • nocturne@sopuli.xyzOP
        4·
        3 months ago

        More than two, those are entire stacks of mana I am using to hold the door in place. I also have a table with a short leg that is leveled with a stack of mountains.

    • morphballganon@lemmy.world
      21·
      3 months ago

      If the door is hollow, you may reveal the cavity inside, which I suppose could be filled in with wood filler. But I don’t think the result would be attractive. disregard, below commenter is correct, and was replying to this paragraph ^

      Another aspect of this solution is that the door isn’t easily replaceable if it has to be planed like this. It’s no longer a rectangle. A replacement door would have to be modified too.

      • wildbus8979@sh.itjust.works
        7·
        3 months ago

        That doesn’t sound likely, there’s usually a frame all around that is at least an inch thick, and probably more like a couple.

        • morphballganon@lemmy.world
          31·
          3 months ago

          Right you are, I was thinking of the depth of the side pieces, not the thickness of the edge pieces.

          Doing that could be fine for making more space at the bottom. It won’t fix how the gap is too big at the top. But if OP doesn’t mind, then no biggie.