for context im in my early 20s and in a decent material condition rn so getting the AA isnt the problem, it’s just deciding which to get

CW: mention of alcoholism

so a friend recommended bica and i was pretty much just about to get it until i saw in the warnings section (on this website: https://healor.com/bicalutamide_mtf) that it said “Do not use or use with caution if you drink heavily” and since i’m an alcoholic (and have been for quite a long time, tried to quit a few times but always started drinking again) i think that i probably shouldn’t go with it.

so since i’m probably not going to be doing bica because of the alcohol related warning, what type of AA would you people advise i get instead?

edit: also how bad could it be if i just went ahead with getting bica anyway, is it worth just trying that out despite the alcohol risk? because it seems to be the best for what i want out of hrt that isnt ludicrously expensive

  • AcidSmiley [she/her]@hexbear.netEnglish
    1·
    1 year ago

    I think bica has some risk of liver damage and that’s why it is contraindicated in case of alcoholism? The same would also apply to cyproterone acetate. Liver health is monitored during regular blood work and normally that makes the risks to the liver from these medications very manageable, but in your case, i think monotherapy is an option you should definitely look into.

  • MYWNcWR9Rgc31zkhTOsA [they/them, she/her]@hexbear.netEnglish
    1·
    1 year ago

    If you do decide to try monotherapy, gel is unlikely to give you blood e levels high enough to suppress testosterone production if it’s applied as directed (upper arms and thighs) https://transfemscience.org/articles/high-dose-transdermal-e2/ You can get higher levels by applying it to your scrotum, but it’s quite irritating https://transfemscience.org/articles/genital-e2-application/

    If you want testosterone suppression without an AA, E injections are generally the best option. Vanna pharma is based in the uk and is reputable (not sure if I can post a link here, but the url is on diyhrt.cafe). Her product has a lower viscosity than Lena’s so you can get away with 29g fixed needles (higher gauge = thinner needle = less pain). You might need 27g or even luer syringes with a low gauge needle for drawing and a higher gauge for injecting if you order injectable e from elsewhere.

    Here’s the 27g needles I used to use with Lena’s EV https://www.exchangesupplies.org/shopdisp_unisharp_fixed_1ml_green_27.php\ Drawing the product from the vial can blunten the tip a little, so occasionally an injection would be a little difficult and painful. It could also take several minutes in winter to draw 0.18ml into the syringe due to the higher viscosity.

    Here’s the 29g I use with Vanna’s EV https://www.exchangesupplies.org/shopdisp_Unisharp_fixed_1ml_yellow_29.php\ These are thinner and I’m yet to have a painful injection. It takes around 15 seconds to draw 0.18ml at current temperatures (5-15C).

    There are several different esters of estradiol available for injection https://transfemscience.org/articles/injectable-e2-meta-analysis/ , but the most common one is estradiol valerate which is often dosed at 0.18ml of 40mg/ml solution (0.18 x 40 = total dose of 7.2mg) every 5 days. Ideally you’d get a blood test after a couple of months so that you can check your levels and adjust your dosage accordingly.